3Com MSR 30, MSR 50 manual Info-center synchronous, Info-center timestamp

2442 CHAPTER 163: INFORMATION CENTER CONFIGURATION COMMANDS

info-center synchronous

Syntax	info-center synchronous
	undo info-center synchronous
View	System view
Parameter	None
Description	Use the info-center synchronous command to enable synchronous information
	output.
	Use the undo info-center synchronous command to disable the synchronous
	information output.
	By default, the synchronous information output is disabled.
n	■ Under the current command line prompt, if the user’s input is interrupted by
	system output such as log information, then after the completion of system
	output the system will not display command line prompt.
	■ When users need to input some interactive information (non Y/N confirmation
	information) if the user’s input is interrupted by system information, then after
	the completion of system output the system will not display command line
	prompt but just print the user’s input.
Example	# Enable synchronous information output.
	<Sysname> system-view
	[Sysname] info-center synchronous
	% Info-center synchronous output is on
	# The user receives trap messages when he/she is about to display the
	configurations for an Ethernet interface by inputting the display interface ethe
	command. After the system has finished its output of trap messages, it will display
	the user’s original input, which is “display interface ethe” in this case.
	<Sysname> system-view
	[Sysname] display interface ethe
	%Apr 29 08:12:44:71 2007 AR29.43 IFNET/4/LINK UPDOWN:
	Ethernet2/1: link status is UP
	[Sysname] display interface ethe
info-center timestamp
Syntax	info-center timestamp { debugging log trap } { boot date none }
	undo info-center timestamp { debugging log trap }

View System view