3Com MSR 50, MSR 30 manual Map ip, # Configure an IP address 10.1.1.1/16 for the VE interface, 301

301

Parameter interface-number: Virtual Ethernet (VE) interface number.

Description Use the map bridge command to establish the IPoEoA mapping or PPPoEoA mapping on the PVC.

Use the undo map bridge command to delete the mapping.

By default, no mapping is configured.

Before using this command, make sure that the VE has been created.

Example The following example demonstrates a complete process of IPoEoA configuration.

# Establish a VE interface virtual-Ethernet 1.

<Sysname> system-view

[Sysname] interface virtual-ethernet 1

# Configure an IP address 10.1.1.1/16 for the VE interface.

[Sysname-Virtual-Ethernet1] ip address 10.1.1.1 255.255.0.0

[Sysname-Virtual-Ethernet1] quit

# Create PVC 1/102 on the ATM interface Atm2/0

[Sysname] interface atm 2/0

[Sysname-Atm2/0] pvc 1/102

# Establish the IPoEoA mapping using the established VE interface in PVC view.

[Sysname-atm-pvc-Atm2/0-1/102] map bridge virtual-ethernet 1

map ip

Syntax In PVC view:

map ip { ip-address[ ip-mask] default inarp [ minutes ] } [ broadcast ]

undo map ip { ip-addressdefault inarp }

In ATM class view:

map ip inarp [ minutes ] [ broadcast ]

undo map ip inarp

View PVC view, ATM class view

Parameter ip-address: Remote IP address mapped to PVC.

ip-mask: IP address mask. It specifies a network segment together with the ip-addressargument. This allows the device to forward an IP packet out of the