NETGEAR UTM25EW-100NAS manual Configuring Routing Information Protocol RIP, Static Route Settings

ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual

3.Enter the settings as explained in Table 4-4.

Table 4-4. Static Route Settings

Setting	Description (or Subfield and Description)
Route Name	The route name for the static route (for purposes of identification and
	management).
Active	To make the static route effective, select the Active checkbox.
	Note: A route can be added to the table and made inactive, if not needed. This
	allows routes to be used as needed without deleting and re-adding the entry.
	an inactive route is not advertised if RIP is enabled.
Private	If you want to limit access to the LAN only, select the Private checkbox. Doing
	so prevents the static route from being advertised in RIP.
Destination IP Address	The destination IP address to the host or network to which the route leads.
IP Subnet Mask	The IP subnet mask to the host or network to which the route leads. If the
	destination is a single host, enter 255.255.255.255.
Interface	From the pull-down menu, select the interface that is the physical network
	interface (WAN1, WAN2, LAN, or DMZ for the UTM25 or WAN, LAN, or DMZ
	for the UTM10) or virtual interface (VLAN profile) through which the route is
	accessible.
Gateway IP Address	The gateway IP address through which the destination host or network can be
	reached.
Metric	The priority of the route. Select a value between 2 and 15. If multiple routes to
	the same destination exist, the route with the lowest metric is used.

4.Click Apply to save your settings. The new static route is added to the Static Route table. To edit a static route that is in the Static Route table:

1.Select its entry from the table and click the edit table button in the Action column. The Edit Static Route screen displays. This screen is identical to the Add Static Route screen that is described above with the exception that you cannot change the name of the static route.

2.Enter the settings as explained in Table 4-4.

3.Click Apply to save your settings.

Configuring Routing Information Protocol (RIP)

Routing Information Protocol (RIP), RFC 2453, is an Interior Gateway Protocol (IGP) that is commonly used in internal networks (LANs). RIP enables a router to exchange its routing information automatically with other routers, to dynamically adjust its routing tables, and to adapt to changes in the network. RIP is disabled by default.

4-24 LAN Configuration

v1.0, September 2009