NETGEAR UTM10EW-100NAS, UTM25-100NAS, UTM25EW-100NAS Configuring Auto-Rollover Mode UTM25 Only

ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual

If your ISP has allocated a number of static IP addresses to you, and you have assigned one of these addresses to each PC, you can choose classical routing. Or, you can use classical routing for routing private IP addresses within a campus environment.

To learn the status of the WAN ports, you can view the System Status screen page (see “Viewing System Status” on page 11-20) or look at the LEDs on the front panel (see “Front Panel” on page 1-9).

To configure classical routing:

1.Select Network Config > WAN Settings from the menu, then click the WAN Mode tab. The WAN Mode screen displays (see Figure 3-8 on page 3-12).

2.In the NAT (Network Address Translation) section of the screen select the Classical Routing radio button.

3.Click Apply to save your settings.

Configuring Auto-Rollover Mode (UTM25 Only)

For the UTM25 only, to use a redundant ISP link for backup purposes, ensure that the backup WAN interface has already been configured. Then select the WAN interface that will act as the primary link for this mode and configure the WAN failure detection method on the WAN Mode screen to support auto-rollover.

When the UTM is configured in auto-rollover mode, it uses the selected WAN failure detection method to check the connection of the primary link at regular intervals to detect router status. Link failure is detected in one of the following ways:

•By sending DNS queries to a DNS server, or

•By sending a ping request to an IP address, or

•None (no failure detection is performed).

From the primary WAN interface, DNS queries or ping requests are sent to the specified IP address. If replies are not received, after a specified number of retries, the primary WAN interface is considered down and a rollover to the backup WAN interface occurs. When the the primary WAN interface comes back up, another rollover occurs from the backup WAN interface back to the primary WAN interface. The WAN failure detection method that you select applies only to the primary WAN interface, that is, it monitors the primary link only.

Manually Configuring Internet and WAN Settings 3-11

v1.0, September 2009