NETGEAR UTM25EW-100NAS, UTM25-100NAS, UTM10EW-100NAS manual Creating a Client to Gateway VPN Tunnel

ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual

Note: When using FQDNs, if the dynamic DNS service is slow to update their servers when your DHCP WAN address changes, the VPN tunnel will fail because the FQDNs do not resolve to your new address. If you have the option to configure the update interval, set it to an appropriately short time.

Creating a Client to Gateway VPN Tunnel

Figure 7-8

Follow the steps in the following sections to configure a VPN client tunnel:

•“Using the VPN Wizard Configure the Gateway for a Client Tunnel” on page 7-8.

•“Using the NETGEAR VPN Client Security Policy Editor to Create a Secure Connection” on page 7-11.

Using the VPN Wizard Configure the Gateway for a Client Tunnel

To set up a client-to-gateway VPN tunnel using the VPN Wizard.

1.Select VPN > IPsec VPN from the menu. The IPsec VPN submenu tabs appear, with the IKE Policies screen in view.

2.Click the VPN Wizard submenu tab. The VPN Wizard screen displays (see Figure 7-9 on page 7-9, which contains some examples for the UTM25). The WAN1 and WAN2 radio buttons are shown on the VPN Wizard screen for the UTM25 but not on the VPN Wizard screen for the UTM10.

7-8 Virtual Private Networking Using IPsec Connections

v1.0, September 2009