NETGEAR UTM10EW-100NAS, UTM25-100NAS, UTM25EW-100NAS manual Restore Settings

ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual

2.Select Save file, and then click OK.

3.Open the folder where you have saved the backup file, and then verify that it has been saved successfully.

Note the following:

•If your browser is not configured to save downloaded files automatically, locate the folder in which you want to save the file, specify the file name, and save the file.

•If you have your browser configured to save downloaded files automatically, the file is saved to your browser’s download location on the hard disk.

Restore Settings

Warning: Restore only settings that were backed up from the same software version. Restoring settings from a different software version can corrupt your backup file or the UTM system software.

To restore settings from a backup file:

1.On the Backup & Restore Settings screen (see Figure 10-5 on page 10-16), next to Restore save settings from file, click Browse.

2.Locate and select the previously saved backup file (by default, backup.pkg).

3.When you have located the file, click the restore button. A warning screen might appear, and you might have to confirm that you want to restore the configuration.

The UTM reboots. During the reboot process, the Backup & Restore Settings screen remains visible. The reboot process is complete after several minutes when the Test LED on the front panel goes off.

Warning: Once you start restoring settings, do not interrupt the process. Do not try to go online, turn off the UTM, shut down the computer, or do anything else to the UTM until the settings have been fully restored.

Network and System Management 10-17

v1.0, September 2009