![](/images/new-backgrounds/1315132/31513231x1.webp)
English
accurately set on your saw.) Since most rooms do not have angles of precisely 90 degrees, you will have to fine tune your settings anyway.
PRETESTING WITH SCRAP MATERIAL IS
EXTREMELY IMPORTANT!
INSTRUCTIONS FOR CUTTING CROWN MOLDING
LAYING FLAT AND USING THE COMPOUND FEATURES
1. Molding laying with broad back surface down flat on saw table (See Figure 26)
2. The settings below are for All Standard (U.S.) crown molding with 52° and 38° angles.
BEVEL SETTING | TYPE OF CUT |
LEFT SIDE, INSIDE CORNER:
33.85° 1. Top of molding against fence
2.Miter table set right 31.62°
3.Save left end of cut
RIGHT SIDE, INSIDE CORNER:
33.85° 1. Bottom of molding against fence 2. Miter table set left 31.62°
3. Save left end of cut
LEFT SIDE, OUTSIDE CORNER:
33.85° 1. Bottom of molding against fence 2. Miter table set left 31.62°
3. Save right end of cut
RIGHT SIDE, OUTSIDE CORNER:
33.85° 1. Top of molding against fence 2. Miter table set right 31.62°
3. Save right end of cut
When setting bevel and miter angles for all |
| |
compound miters, remember that: |
| |
The angles presented for crown moldings are very |
| |
precise and difficult to set exactly. Since they can |
| |
easily shift slightly and very few rooms have exactly | FIG. 25 | |
square corners, all settings should be tested on | ||
| ||
scrap molding. |
| |
PRETESTING WITH SCRAP MATERIAL IS |
| |
EXTREMELY IMPORTANT! |
|
ALTERNATIVE METHOD FOR CUTTING CROWN MOLDING
Place the molding on the table at an angle between the fence and the saw table, as shown in Figure 26A. Use of the crown molding fence accessory (DW7054) is highly recommended because of its degree of accuracy and convenience. The crown molding fence accessory is available at extra cost from your local dealer.
The advantage to cutting crown molding using this method is that no bevel cut is required. Minute changes in the miter angle can be made without affecting the bevel angle.
FIG. 23
FIG. 24
FIG. 26
FENCE
TABLE
CROWN MOLDING FLAT ON TABLE AND AGAINST FENCE
FIG. 26A
BOTTOM SIDE |
|
OF MOLDING | DW 7054 CROWN |
TOP SIDE | MOLDING FENCE |
| |
OF MOLDING | TABLE |
| |
FENCE |
|
CROWN MOLDING BETWEEN FENCE AND TABLE
| BLADE |
RIGHT | FIG. 27 |
FENCE |
|
12