DeWalt Compound Miter Saw manual Wrong, Special Cuts Never Make ANY CUT Unless the Material is

BLADE

WRONG FIG. 28

FENCE

FIG. 29

RIGHT

TABLE 1 COMPOUND MITER CUT (POSITION WOOD WITH BROAD FLAT SIDE ON THE TABLE AND THE NARROW EDGE AGAINST THE FENCE)

		5		10											English
					15
							20
								25
									30
SAW										35	SQUARE
										40					A)
											45	BOX
	5		10	15								50	•		26.5˚
SET THIS MITERANGLEON					20										ANGLE OF SIDE OF(ANGLEBOX
					25				6			55
						30
									-
								35	SIDED
								40					60
	5
		10								BOX
			15	20			8		45
					25		-		50				65
					30		SIDED
	SETTING				35					55
						40		BOX
														70
							45			60
								50		65
								55						75
	DEGREE							60
										70
								65
								70		75				80
	MITER							75		80
									80	85				85
		BEVEL DEGREE SETTING							85
													38˚

SET THIS BEVEL ANGLE ON SAW

FIG. 30

WRONG

This way, when corners other than 90 degrees are encountered, the saw can be quickly and easily adjusted for them. Use the crown molding fence accessory to maintain the angle at which the molding will be on the wall.

INSTRUCTIONS FOR CUTTING CROWN MOLDING ANGLED BETWEEN THE FENCE AND BASE OF THE SAW FOR ALL CUTS:

1.Angle the molding so the bottom of the molding (part which goes against the wall when installed) is against the fence and the top of the molding is resting on the base of the saw, as shown in Figure 26A.

2.The angled “flats” on the back of the molding must rest squarely on the fence and base of the saw.

INSIDE CORNER:

Left side

1.Miter right at 45°

2.Save the right side of cut

Right side

1.Miter left at 45°

2.Save left side of cut

OUTSIDE CORNER:

Left side

1.Miter left at 45°

2.Save right side of cut

Right side

1.Miter right at 45°

2.Save left side of cut

SPECIAL CUTS

NEVER MAKE ANY CUT UNLESS THE MATERIAL IS

13