NETGEAR UTM10EW-100NAS, UTM25-100NAS, UTM25EW-100NAS manual Add VPN Policy Settings, General

ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual

4.Complete the fields, select the radio buttons and checkboxes, and make your selections from the pull-down menus as explained Table 7-12.

Table 7-12. Add VPN Policy Settings

	Item	Description (or Subfield and Description)
	General
	Policy Name	A descriptive name of the VPN policy for identification and management
		purposes.
		Note: The name is not supplied to the remote VPN endpoint.
	Policy Type	From the pull-down menu, select one of the following policy types:
		• Auto Policy. Some settings (the ones in the Manual Policy Parameters
		section of the screen) for the VPN tunnel are generated automatically.
		• Manual Policy. All settings must be specified, including the ones in the
		Manual Policy Parameters section of the screen.
	Select Local Gateway	For the UTM25 only, select a radio button to specify the WAN1 or WAN2
	(UTM25 only)	interface.
	Remote Endpoint	Select a radio button to specify how the remote endpoint is defined:
		• IP Address. Enter the IP address of the remote endpoint in the fields to
		the right of the radio button.
		• FQDN. Enter the FQDN of the remote endpoint in the field to the right of
		the radio button.
	Enable NetBIOS?	Select this checkbox to allow NetBIOS broadcasts to travel over the VPN
		tunnel. For more information about NetBIOS, see “Configuring NetBIOS
		Bridging with IPsec VPN” on page 7-58. This feature is disabled by default.
	Enable RollOver?	Select this checkbox to allow the VPN tunnel to roll over to the other WAN
		interface when the WAN mode is set to Auto-Rollover and an actual rollover
		occurs. This feature is disabled by default.
	Enable Keepalive	Select a radio button to specify if Keepalive is enabled:
		• Yes. This feature is enabled: periodically, the UTM sends ping packets to
	Note: See also	the remote endpoint to keep the tunnel alive. You must enter the ping IP
	“Configuring Keepalives	address, detection period, and the maximum number of times that the
	and Dead Peer	UTM attempts to reconnect (see below).
	Detection” on page 7-54.	• No. This feature is disabled. This is the default setting.
		Ping IP Address	The IP address that the UTM pings. The address must be
			of a host that can respond to ICMP ping requests.
		Detection period	The period in seconds between the ping packets. The
			default setting is 10 seconds.
		Reconnect after	The number of consecutive missed responses that are
		failure count	considered a tunnel connection failure. The default
			setting is 3 missed responses.
7-34			Virtual Private Networking Using IPsec Connections

v1.0, September 2009