NETGEAR UTM25-100NAS Managing Routing, Setting Description or Subfield and Description DNS Proxy

ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual

Table 4-3. DMZ Setup Settings (continued)

Setting	Description (or Subfield and Description)
DNS Proxy
Enable DNS Proxy	This is optional. Select the Enable DNS Proxy radio button to enable the UTM
	to provide a LAN IP address for DNS address name resolution. This setting is
	enabled by default.
	Note: The UTM still services DNS requests sent to its LAN IP address unless
	you disable DNS Proxy in the firewall settings (see “Attack Checks” on
	page 5-20).

3.Click Apply to save your settings.

Note: The DMZ LED next to LAN port 4 (see “Front Panel” on page 1-9) lights green to indicate that the DMZ port is enabled.

To define the DMZ WAN Rules and LAN DMZ Rules, see “Setting DMZ WAN Rules” on page 5-14and “Setting LAN DMZ Rules” on page 5-18, respectively.

Managing Routing

Static Routes provide additional routing information to your UTM. Under normal circumstances, the has adequate routing information after it has been configured for Internet access, and you do not need to configure additional static routes. You should configure static routes only for unusual cases such as multiple firewalls or multiple IP subnets located on your network.

Note: The automatically sets up routes between VLANs and secondary IP addresses that you have configured on the LAN Multi-homing screen (see “Configuring Multi- Home LAN IPs on the Default VLAN” on page 4-11). Therefore, you do not need to manually add a static route between a VLAN and a secondary IP address.

4-22 LAN Configuration

v1.0, September 2009