NETGEAR UTM25EW-100NAS, UTM25-100NAS, UTM10EW-100NAS manual Network and System Management

ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual

Warning: This feature is for advanced administrators only! Incorrect configuration might cause serious problems.

Each rule lets you specify the desired action for the connections covered by the rule:

•BLOCK always

•BLOCK by schedule, otherwise Allow

•ALLOW always

•ALLOW by schedule, otherwise Block

The section below summarizes the various criteria that you can apply to inbound rules and that might increase traffic. For more information about inbound rules, see “Inbound Rules (Port Forwarding)” on page 5-6. For detailed procedures on how to configure inbound rules, see “Setting LAN WAN Rules” on page 5-11and “Setting DMZ WAN Rules” on page 5-14.

When you define inbound firewall rules, you can further refine their application according to the following criteria:

•Services. You can specify the services or applications to be covered by an inbound rule. If the desired service or application does not appear in the list, you must define it using the Services screen (see “Services-Based Rules” on page 5-3and “Adding Customized Services” on page 5-30).

•WAN Destination IP Address. For the UTM25, you can specify the destination IP address for incoming traffic. Traffic is directed to the specified address only when the destination IP address of the incoming packet matches the IP address of the selected WAN interface (that is WAN1 or WAN2 interface). For the UTM10 with its single WAN interface, the WAN Destination IP Address is a fixed field.

•LAN Users. You can specify which computers on your network are affected by an inbound rule. There are several options:

–Any. All PCs and devices on your LAN.

–Single address. The rule is applied to the address of a particular PC.

–Address range. The rule is applied to a range of addresses.

10-6 Network and System Management

v1.0, September 2009