NETGEAR UTM25EW-100NAS, UTM25-100NAS Description or Subfield and Description Traffic Selection

ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual

Table 7-12. Add VPN Policy Settings (continued)

	Item	Description (or Subfield and Description)
	Traffic Selection
	Local IP	From the pull-down menu, select the address or addresses that are part of
		the VPN tunnel on the UTM:
		• Any. All PCs and devices on the network.
		Note: You cannot select Any for both the UTM and the remote endpoint.
		• Single. A single IP address on the network. Enter the IP address in the
		Start IP Address field.
		• Range. A range of IP addresses on the network. Enter the starting IP
		address in the Start IP Address field and the ending IP address in the End
		IP Address field.
		• Subnet. A subnet on the network. Enter the starting IP address in the Start
		IP Address field and the subnet mask in the Subnet Mask field.
	Remote IP	From the pull-down menu, select the address or addresses that are part of
		the VPN tunnel on the remote endpoint. The menu choices are the same as
		for the Local IP pull-down menu (see above).
	Manual Policy Parameters
	Note: These fields apply only when you select Manual Policy as the policy type. When you specify the
	settings for the fields in this section, a security association (SA) is created.
	SPI-Incoming	The Security Parameters Index (SPI) for the inbound policy. Enter a
		hexadecimal value between 3 and 8 characters (for example: 0x1234).
	Encryption Algorithm	From the pull-down menu, select one of the following five algorithms to
		negotiate the security association (SA):
		• DES. Data Encryption Standard (DES)
		• 3DES. Triple DES. This is the default algorithm.
		• AES-128. Advanced Encryption Standard (AES) with a 128-bits key size.
		• AES-192. AES with a 192-bits key size.
		• AES-256. AES with a 256-bits key size.
	Key-In	The encryption key for he inbound policy. The length of the key depends on
		the selected encryption algorithm:
		• DES: enter 8 characters.
		• 3DES: enter 24 characters.
		• AES-128: enter 16 characters.
		• AES-192: enter 24 characters.
		• AES-256: enter 32 characters.
	Key-Out	The encryption key for he outbound policy. The length of the key depends on
		the selected encryption algorithm. The required key lengths are the same as
		for the Key-In (se above).
	SPI-Outgoing	The Security Parameters Index (SPI) for the outbound policy. Enter a
		hexadecimal value between 3 and 8 characters (for example: 0x1234).
Virtual Private Networking Using IPsec Connections			7-35

v1.0, September 2009