NETGEAR UTM10EW-100NAS, UTM25-100NAS, UTM25EW-100NAS manual Problems with Date and Time

ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual

Figure 12-1

b.Click the default button.

The UTM reboots. During the reboot process, the Backup & Restore Settings screen remains visible. The reboot process is complete after several minutes when the Test LED on the front panel goes off.

Warning: When you push the hardware Reset button or click the software default button, the UTM settings are erased. All firewall rules, VPN policies, LAN/ WAN settings, and other settings are lost. Back up your settings if you intend on using them.

Note: After rebooting with factory default settings, the UTM’s password is password and the LAN IP address is 192.168.1.1.

Problems with Date and Time

The System Date & Time screen displays the current date and time of day (see “Configuring Date and Time Service” on page 10-24). The UTM uses the Network Time Protocol (NTP) to obtain the current time from one of several Network Time Servers on the Internet. Each entry in the log is stamped with the date and time of day. Problems with the date and time function can include:

•Date shown is January 1, 2000. Cause: The UTM has not yet successfully reached a Network Time Server. Check that your Internet access settings are configured correctly. If you have just completed configuring the UTM, wait at least five minutes and check the date and time again.

Troubleshooting and Using Online Support 12-9

v1.0, September 2009