NETGEAR UTM25EW-100NAS, UTM25-100NAS Choosing a Location for the UTM, Using the Rack-Mounting Kit

ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual

Choosing a Location for the UTM

The UTM is suitable for use in an office environment where it can be free-standing (on its runner feet) or mounted into a standard 19-inch equipment rack. Alternatively, you can rack-mount the UTM in a wiring closet or equipment room. A rack mounting kit, containing two mounting brackets and four screws, is provided in the UTM25 package.

Consider the following when deciding where to position the UTM:

•The unit is accessible and cables can be connected easily.

•Cabling is away from sources of electrical noise. These include lift shafts, microwave ovens, and air-conditioning units.

•Water or moisture cannot enter the case of the unit.

•Airflow around the unit and through the vents in the side of the case is not restricted. Provide a minimum of 25 mm or 1 inch clearance.

•The air is as free of dust as possible.

•Temperature operating limits are not likely to be exceeded. Install the unit in a clean, air- conditioned environment. For information about the recommended operating temperatures for the UTM, see Appendix A, “Default Settings and Technical Specifications.”

Using the Rack-Mounting Kit

Use the mounting kit for the UTM to install the appliance in a rack. (A mounting kit is provided in the product package for the UTM25). Attach the mounting brackets using the hardware that is supplied with the mounting kit.

Figure 1-6

Before mounting the UTM in a rack, verify that:

•You have the correct screws (supplied with the installation kit).

•The rack onto which you will mount the UTM is suitably located.

1-14 Introduction

v1.0, September 2009