NETGEAR UTM10EW-100NAS manual IPsec VPN Wizard Settings for a Client-to-Gateway Tunnel, Fqdn

ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual

3.Select the radio buttons and complete the fields and as explained Table 7-3.

Table 7-3. (IPsec) VPN Wizard Settings for a Client-to-Gateway Tunnel

Setting	Description (or Subfield and Description)
About VPN Wizard
This VPN tunnel will connect	Select the VPN Client radio button. The default remote FQDN
to the following peers	(utm_remote.com) and the default local FQDN (utm_local.com) appear
	in the End Point Information section of the screen.
Connection Name and Remote IP Type
What is the new Connection	Enter a descriptive name for the connection. This name is used to help
Name?	you to manage the VPN settings; the name is not supplied to the
	remote VPN endpoint.
What is the pre-shared key?	Enter a pre-shared key. The key must be entered both here and on the
	remote VPN gateway, or the remote VPN client. This key must have a
	minimum length of 8 characters and should not exceed 49 characters.
This VPN tunnel will use	For the UTM25 only, select one of the two radio buttons (WAN1 or
following local WAN Interface	WAN2) to specify which local WAN interface the VPN tunnel uses as
(UTM25 only)	the local endpoint.
	Note: If the UTM25 is configured to function in WAN auto-rollover
	mode, after completing the wizard, you must manually update the VPN
	policy to enable VPN rollover. For more information, see “Manually
	Adding or Editing a VPN Policy” on page 7-32.
End Point Informationa
What is the Remote Identifier	When you select the Client radio button in the About VPN Wizard
Information?	section of the screen, the default remote FQDN (utm_remote.com) is
	automatically entered. Use the default remote FQDN or enter another
	FQDN.
What is the Local Identifier	When you select the Client radio button in the About VPN Wizard
Information?	section of the screen, the default local FQDN (utm_local.com) is
	automatically entered. Use the default local FQDN or enter another
	FQDN.
Secure Connection Remote Accessibility
What is the remote LAN IP
Address?	These fields are masked out for VPN client connections.
What is the remote LAN
Subnet Mask?

a. Both local and remote endpoints should be defined as either FQDNs or IP addresses. A combination of an IP address and a FQDN is not supported.

.

7-10 Virtual Private Networking Using IPsec Connections

v1.0, September 2009