NETGEAR UTM25EW-100NAS, UTM25-100NAS, UTM10EW-100NAS manual Registering the UTM with Netgear

ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual

Verify that the UTM properly scans HTTP traffic:

1.Log on to the UTM Web Management Interface, and then verify that HTTP scanning is enabled. For information about how to enable HTTP scanning, see “Customizing Web Protocol Scan Settings and Services” on page 6-19and “Configuring Web Malware Scans” on page 6-21.

2.Check the downloaded eicar.com test file, and note the attached malware information file.

Registering the UTM with NETGEAR

To receive threat management component updates and technical support, you must register your UTM with NETGEAR. The support registration key is provided with the product package (see “Service Registration Card with License Keys” on page 1-8).

Note: Activating the service licenses initiates their terms of use. Activate the licenses only when you are ready to start using this unit. If your unit has never been registered before you can use the 30-day trial period for all 3 types of licenses to perform the initial testing and configuration. To use the trial period, do not click Register in step 4 of the procedure below but click Trial instead.

Using the Setup Wizard to Provision the UTM in Your Network 2-27

v1.0, September 2009