
xStack
config igmp_snooping
| default is 260 seconds. |
| leave_timer <sec |
| seconds. |
| state [enabled disabled] − Allows the user to enable or disable |
| IGMP snooping for the specified VLAN. |
Restrictions | Only |
|
|
Example usage:
To configure IGMP snooping:
Success.
config igmp_snooping querier
Purpose | This command configures IGMP snooping querier. |
Syntax | config igmp_snooping querier [<vlan_name 32> all] |
| {query_interval <sec |
| 25> robustness_variable <value |
| last_member_query_interval <sec |
| disabled]} |
Description | Used to configure the time in seconds between general query |
| transmissions, the maximum time in seconds to wait for reports |
| from members and the permitted packet loss that guarantees |
| IGMP snooping. |
Parameters | <vlan_name 32> − The name of the VLAN for which IGMP |
| snooping querier is to be configured. |
| all – Selecting this parameter will configure the IGMP snooping |
| querier for all VLANs on the Switch. |
| query_interval <sec |
| seconds between general query transmissions. The default |
| setting is 125 seconds. |
| max_response_time <sec |
| seconds to wait for reports from members. The default setting is |
| 10 seconds. |
| robustness_variable <value |
| allow for expected packet loss on a subnet. The value of the |
| robustness variable is used in calculating the following IGMP |
| message intervals: |
| • Group membership |
| pass before a multicast router decides there are no more |
| members of a group on a network. This interval is |
| calculated as follows: (robustness variable x query |
144