D-Link TM DES-6500 manual 129

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual

Parameters	group _id <value 1-32>− Specifies the group ID. The Switch allows up
	to 32 link aggregation groups to be configured. The group number
	identifies each of the groups.
	master_port <port> − Master port ID. Specifies which port (by port
	number) of the link aggregation group will be the master port. All of the
	ports in a link aggregation group will share the port configuration with
	the master port. The port is specified by listing the lowest slot number
	and the beginning port number on that slot, separated by a colon. For
	example, 1:3 specifies switch number 1, port 3. 2:4 specifies switch
	number 2, port 4.
	ports <portlist> − Specifies a range of ports that will belong to the link
	aggregation group. The port list is specified by listing the lowest slot
	number and the beginning port number on that slot, separated by a
	colon. Then the highest slot number, and the highest port number of
	the range (also separated by a colon) are specified. The beginning and
	end of the port list range are separated by a dash. For example, 1:3
	specifies slot number 1, port 3. 2:4 specifies slot number 2, port 4. 1:3-
	2:4 specifies all of the ports between slot 1, port 3 and slot 2, port 4 − in
	numerical order.
	state [enabled disabled] − Allows the user to enable or disable the
	specified link aggregation group.
Restrictions	Only administrator-level users can issue this command. Link
	aggregation groups may not overlap.

Example usage:

To define a load-sharing group of ports, group-id 1,master port 5 of module 1 with group members ports 5-7 plus port 9:

DES-6500:4#config link_aggregation group_id 1 master_port 1:5 ports 1:5-1:7, 1:9 Command: config link_aggregation group_id 1 master_port 1:5 ports 1:5-1:7, 1:9

Success.

DES-6500:4#

129