D-Link TM DES-6500 manual Config authenenable default methodlistname string

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual

DES-6500:4#create authen_enable method_list_name Permit

Command: show authen_login method_list_name Permit

Success.

DES-6500:4#

config authen_enable

Purpose	Used to configure a user-defined method list of authentication
	methods for promoting normal user level privileges to Administrator
	level privileges on the Switch.
Syntax	config authen_enable [default method_list_name <string 15>]
	method {tacacs xtacacs tacacs+ radius server_group
	<string 15> local_enable none}
Description	This command is used to promote users with normal level privileges
	to Administrator level privileges using authentication methods on the
	Switch. Once a user acquires normal user level privileges on the
	Switch, he or she must be authenticated by a method on the Switch
	to gain administrator privileges on the Switch, which is defined by
	the Administrator. A maximum of eight (8) method lists can be
	implemented on the Switch.
	The sequence of methods implemented in this command will affect
	the authentication result. For example, if a user enters a sequence of
	methods like tacacs – xtacacs – local_enable, the Switch will send
	an authentication request to the first tacacs host in the server group.
	If no verification is found, the Switch will send an authentication
	request to the second tacacs host in the server group and so on,
	until the list is exhausted. At that point, the Switch will restart the
	same sequence with the following protocol listed, xtacacs. If no
	authentication takes place using the xtacacs list, the local_enable
	password set in the Switch is used to authenticate the user.
	Successful authentication using any of these methods will give the
	user a “Admin” privilege.
Parameters	default – The default method list for administration rights
	authentication, as defined by the user. The user may choose one or
	a combination of up to four (4) of the following authentication
	methods:
	tacacs – Adding this parameter will require the user to be
	authenticated using the TACACS protocol from the remote
	TACACS server hosts of the TACACS server group list.
	xtacacs – Adding this parameter will require the user to be
	authenticated using the XTACACS protocol from the remote
	XTACACS server hosts of the XTACACS server group list.
	tacacs+ – Adding this parameter will require the user to be
	authenticated using the TACACS+ protocol from the remote
	TACACS+ server hosts of the TACACS+ server group list.
	radius - Adding this parameter will require the user to be
	authenticated using the RADIUS protocol from a remote
	RADIUS server previously implemented on the Switch.
	server_group <string 15> – Adding this parameter will

160