
xStack
To enable IGMP snooping on the Switch:
Command: enable igmp_snooping
Success.
disable igmp_snooping
Purpose | Used to enable IGMP snooping on the Switch. |
Syntax | disable igmp_snooping {forward_mcrouter_only} |
Description | This command disables IGMP snooping on the Switch. IGMP |
| snooping can be disabled only if IP multicast routing is not being |
| used. Disabling IGMP snooping allows all IGMP and IP multicast |
| traffic to flood within a given IP interface. If |
| forward_mcrouter_only is specified, the Switch will forward all |
| multicast traffic to any IP router. |
Parameters | forward_mcrouter_only − Specifies that the Switch will forward all |
| multicast traffic to any IP router. |
Restrictions | Only |
|
|
Example usage:
To disable IGMP snooping on the Switch:
Command: disable igmp_snooping
Success.
config router_ports
Purpose | Used to configure ports as router ports. |
Syntax | config router_ports <vlan_name 32> [add delete] <portlist> |
Description | This command allows the designation of a range of ports as |
| being connected to |
| that all packets with such a router as its destination will reach the |
| |
Parameters | <vlan_name 32> − The name of the VLAN on which the router |
| port resides. |
| [add delete] – Specifies whether to add or delete the following |
| ports as router ports. |
| <portlist> − Specifies a range of ports that will be configured as |
| router ports. The port list is specified by listing the lowest slot |
146