
xStack
16
LINK AGGREGATION COMMANDS
The link aggregation commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command | Parameters |
create link_aggregation | group_id <value |
|
|
delete link_aggregation | group_id <value |
|
|
config link_aggregation | group_id |
| state [enabled disabled]} |
|
|
config link_aggregation | [mac_source mac_destination mac_source_dest ip_source |
algorithm | ip_destination ip_source_dest] |
|
|
show link_aggregation | {group_id <value |
|
|
config lacp_port | <portlist> mode [active passive] |
|
|
show lacp_port | {<portlist>} |
|
|
Each command is listed, in detail, in the following sections.
create link_aggregation
Purpose | Used to create a link aggregation group on the Switch. |
Syntax | create link_aggregation group_id <value |
| static]} |
Description | This command will create a link aggregation group with a unique |
| identifier. |
Parameters | <value |
| link aggregation groups to be configured. The group number |
| identifies each of the groups. |
| type – Specify the type of link aggregation used for the group. If |
| the type is not specified the default type is static. |
| lacp – This designates the port group as LACP compliant. |
| LACP allows dynamic adjustment to the aggregated port |
| group. LACP compliant ports may be further configured (see |
| config lacp_ports). LACP compliant must be connected to |
| LACP compliant devices. |
| static – This designates the aggregated port group as |
| static. Static port groups can not be changed as easily as |
| LACP compliant port groups since both linked devices must |
| be manually configured if the configuration of the trunked |
| group is changed. If static link aggregation is used, be sure |
| that both ends of the connection are properly configured and |
| that all ports have the same speed/duplex settings. |
Restrictions | Only |
|
|
Example usage:
To create a link aggregation group:
127