D-Link TM DES-6500 manual ARP Commands, Delete arpentry, Create arpentry ipaddr macaddr

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual

30

ARP COMMANDS

The ARP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.

Command	Parameters
create arpentry	<ipaddr> <macaddr>
delete arpentry	[<ipaddr> all]
show arpentry	{ipif <ipif_name 12> static}
show arpentry	<ipaddr>
ipaddress
config arp_aging time	<value 0-65535>
clear arptable

Each command is listed, in detail, in the following sections.

create arpentry

	Purpose	Used to make a static entry into the ARP table.
	Syntax	create arpentry <ipaddr> <macaddr>
	Description	This command is used to enter an IP address and the
		corresponding MAC address into the Switch’s ARP table.
	Parameters	<ipaddr> − The IP address of the end node or station.
		<macaddr> − The MAC address corresponding to the IP address
		above.
	Restrictions	Only administrator-level users can issue this command.
Example Usage:

To create a static ARP entry for the IP address 10.48.74.121 and MAC address 00:50:BA:00:07:36:

DES-6500:4#create arpentry 10.48.74.121 00-50-BA-00-07-36

Command: create arpentry 10.48.74.121 00-50-BA-00-07-36

Success.

DES-6500:4#

delete arpentry

Purpose	Used to delete a static entry into the ARP table.
Syntax	delete arpentry {<ipaddr> all}
Description	This command is used to delete a static ARP entry, made using
	the create arpentry command above, by specifying either the IP
	address of the entry or all. Specifying all clears the Switch’s ARP

257