
xStack
35
DNS RELAY COMMANDS
The DNS relay commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command | Parameters |
config dnsr | [[primary secondary] nameserver <ipaddr> [add delete] |
| static <domain_name 32> <ipaddr>] |
enable dnsr | {cache static} |
|
|
disable dnsr | {cache static} |
|
|
show dnsr | {static} |
|
|
Each command is listed, in detail, in the following sections.
config dnsr
Purpose | Used to configure the DNS relay function. |
Syntax | config dnsr [[primary secondary] nameserver <ipaddr> |
| [add delete] static <domain_name 32> <ipaddr>] |
Description | This command is used to configure the DNS relay function on |
| the Switch. |
Parameters | primary − Indicates that the IP address below is the address of |
| the primary DNS server. |
| secondary − Indicates that the IP address below is the address |
| of the secondary DNS server. |
| nameserver <ipaddr> − The IP address of the DNS nameserver. |
| [add delete] – Indicates whether to add or delete the DNS relay |
| function. |
| <domain_name 32> − The domain name of the entry. |
| <ipaddr> − The IP address of the entry. |
Restrictions | Only |
|
|
Example Usage:
To set IP address 10.43.21.12 of primary.
Command: config dnsr primary 10.43.21.12
Success
Example Usage:
To add an entry domain name dns1, IP address 10.43.21.12 to DNS static table:
283