D-Link TM DES-6500 manual 218

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual

config access_profile profile_id (IP)

packet to see if it will be either forwarded or filtered based on one or more of the following:

•vlan <vlan_name 32> − Specifies that the access profile will apply to only to this VLAN.

•source_ip <ipaddr> − Specifies that the access profile will apply to only packets with this source IP address.

•destination_ip <ipaddr> − Specifies that the access profile will apply to only packets with this destination IP address.

•dscp <value 0-63>− Specifies that the access profile will apply only to packets that have this value in their Type-of-Service (DiffServ code point, DSCP) field in their IP packet header.

•icmp − Specifies that the Switch will examine the Internet Control Message Protocol (ICMP) field within each packet.

•type <value 0-255>− Specifies that the access profile will apply to this ICMP type defined by a value between 0 and 255.

•code <value 0-255>− Specifies that the access profile will apply to this ICMP code defined by a value between 0 and 255.

•igmp − Specifies that the Switch will examine the Internet Group Management Protocol (IGMP) field within each packet.

•type <value 0-255>− Specifies that the access profile will apply to packets that have this IGMP type defined by a value between 0 and 255..

•tcp − Specifies that the Switch will examine the Transmission Control Protocol (TCP) field within each packet.

•src_port <value 0-65535>− Specifies that the access profile will apply only to packets that have this TCP source port in their TCP header.

•dst_port <value 0-65535>− Specifies that the access profile will apply only to packets that have this TCP destination port in their TCP header.

•flag_mask – Enter the type of TCP flag to be masked. The choices are:

•urg: TCP control flag (urgent)

•ack: TCP control flag (acknowledgement)

•psh: TCP control flag (push)

•rst: TCP control flag (reset)

•syn: TCP control flag (synchronize)

•fin: TCP control flag (finish)

•udp − Specifies that the Switch will examine the Universal Datagram Protocol (UDP) field in each packet.

•src_port <value 0-65535>− Specifies that the access profile will apply only to packets that have this UDP source port in their header.

•dst_port <value 0-65535>− Specifies that the access profile will apply only to packets that have this UDP destination port in

218