D-Link TM DES-6500 manual Network Monitoring Commands, Show packet ports portlist

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual

9

NETWORK MONITORING COMMANDS

The network monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.

Command	Parameters
show packet ports	<portlist>
show error ports	<portlist>
show utilization	[ports cpu]
show stack information
clear counters	ports <portlist>
clear log
show log	index <value_list>
enable syslog
disable syslog
show syslog
create syslog host	[<index 1-4> all] {severity [informational warning all] facility
	[local0 local1 local2 local3 local4 local5 local6 local7]
	udp_port <udp_port_number> ipaddress <ipaddr> state
	[enabled disabled]}
config syslog host	<index 1-4> {severity [informational warning all] facility [local0
	local1 local2 local3 local4 local5 local6 local7] udp_port
	<udp_port_number> ipaddress <ipaddr> state [enabled
	disabled]}
config syslog host all	{severity [informational warning all] facility [local0 local1
	local2 local3 local4 local5 local6 local7] udp_port
	<udp_port_number> state [enabled disabled]}
delete syslog host	[<index 1-4> all]
show syslog host	[<index 1-4>]
config system_severity	[trap log all] [critical warning information]
show system_severity

Each command is listed, in detail, in the following sections.

show packet ports

Purpose	Used to display statistics about the packets sent and received by
	the Switch.
Syntax	show packet ports <portlist>
Description	This command is used to display statistics about packets sent and
	received by ports specified in the port list. The results are
	separated into three tables, labeled A, B, and C in the window
	above. Table A is relevant to the size of the packets, Table B is
	relevant to the type of packets and Table C is relevant to the type
	of frame associated with these packets.

58