D-Link TM DES-6500 manual Create ospf virtuallink areaid neighborid

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual

create ospf virtual_link

Purpose	Used to create an OSPF virtual interface.
Syntax	create ospf virtual_link <area_id> <neighbor_id>
	{hello_interval <sec 1-65535> dead_interval <sec 1-65535>
	authentication [none simple <password 8> md5 <key_id 1-
	255>]}
Description	This command is used to create an OSPF virtual interface.
Parameters	<area_id> − A 32-bit number in the form of an IP address
	(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
	OSPF domain.
	<neighbor_id> − The OSPF router ID for the remote area. This is
	a 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx)
	that uniquely identifies the remote area’s Area Border Router.
	The router ID of the neighbor router.
	hello_interval <sec 1-65535>− Allows the specification of the
	interval between the transmission of OSPF Hello packets, in
	seconds. Between 1 and 65535 seconds can be specified. The
	Hello Interval, Dead Interval, Authorization Type, and
	Authorization Key should be the same for all routers on the same
	network.
	dead_interval <sec 1-65535>− Allows the specification of the
	length of time between the receipt of Hello packets from a
	neighbor router before the selected area declares that router
	down. An interval between 1 and 65535 seconds can be
	specified. The Dead Interval must be evenly divisible by the Hello
	Interval.
	authentication – Enter the type of authentication preferred. The
	user may choose between:
	• none – Choosing this parameter will require no
	authentication.
	• simple <password 8> − Choosing this parameter will set a
	simple authentication which includes a case-sensitive
	password of no more than 8 characters.
	• md5 <key_id 1-255>− Choosing this parameter will set
	authentication based on md5 encryption. A previously
	configured MD5 key ID (1 to 255) is required.
Restrictions	Only administrator-level users can issue this command.

Usage Example

To create an OSPF virtual interface:

DES-6500:4#create ospf virtual_link 10.1.12 20.1.1.1 hello_interval 10

Command: create ospf virtual_link 10.1.12 20.1.1.1 hello_interval 10

Success.

DES-6500:4#

319