
xStack
config lacp_port
Purpose | Used to configure settings for LACP compliant ports. |
Syntax | config lacp_port <portlist> mode [active passive] |
Description | This command is used to configure ports that have been |
| previously designated as LACP ports (see create |
| link_aggregation). |
Parameters | <portlist> − Specifies a range of ports to be configured. The port |
| list is specified by listing the lowest slot number and the beginning |
| port number on that slot, separated by a colon. Then the highest |
| slot number, and the highest port number of the range (also |
| separated by a colon) are specified. The beginning and end of the |
| port list range are separated by a dash. For example, 1:3 specifies |
| slot number 1, port 3. 2:4 specifies slot number 2, port 4. |
| specifies all of the ports between slot 1, port 3 and slot 2, port 4 − |
| in numerical order. |
| mode – Select the mode to determine if LACP ports will initially |
| send LACP control frames. |
| active – Active LACP ports are capable of processing and |
| sending LACP control frames. This allows LACP compliant |
| devices to negotiate the aggregated link so the group may be |
| changed dynamically as needs require. In order to utilize the |
| ability to change an aggregated port group, that is, to add or |
| subtract ports from the group, at least one of the participating |
| devices must designate LACP ports as active. Both devices |
| must support LACP. |
| passive – LACP ports that are designated as passive |
| cannot initially send LACP control frames, unless the port |
| receives LACP frames. In order to allow the linked port group |
| to negotiate adjustments and make changes dynamically, at |
| one end of the connection must have “active” LACP ports |
| (see above). |
Restrictions | Only |
|
|
Example usage:
To configure LACP port mode settings:
Command: config lacp_port
Success.
132