D-Link TM DES-6500 manual RIP Commands, Config rip

Models: TM DES-6500

1 334
Download 334 pages 1.5 Kb
Page 290
Image 290

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual

36

RIP COMMANDS

The RIP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.

Command

Parameters

config rip

[ipif <ipif_name 12> all] {authentication [enabled <password

 

16> disabled] tx_mode [disabled v1_only v1_compatible

 

v2_only] rx_mode [v1_only v2_only v1_or_v2 disabled]

 

state [enabled disabled]}

enable rip

 

 

 

disable rip

 

 

 

show rip

ipif <ipif_name 12>

 

 

Each command is listed, in detail, in the following sections.

config rip

Purpose

Used to configure RIP on the Switch.

Syntax

config rip [ipif <ipif_name 12> all] {authentication [enabled

 

<password 16> disabled] tx_mode [disabled v1_only

 

v1_compatible v2_only] rx_mode [v1_only v2_only

 

v1_or_v2 disabled] state [enabled disabled]}

Description

This command is used to configure RIP on the Switch.

Parameters

<ipif_name 12> The name of the IP interface.

 

all – To configure all RIP receiving mode for all IP interfaces.

 

authentication [enabled disabled] Enables or disables

 

authentication for RIP on the Switch.

 

<password 16> Allows the specification of a case-

 

sensitive password.

 

tx_mode Determines how received RIP packets will be

 

interpreted – as RIP version V1 only, V2 Only, or V1 Compatible

 

(V1 and V2). This entry specifies which version of the RIP

 

protocol will be used to transfer RIP packets. The disabled entry

 

prevents the reception of RIP packets.

 

disable Prevents the transmission of RIP packets.

 

v1_only Specifies that only RIP v1 packets will be

 

transmitted.

 

v1_compatible – Specifies that only RIP v1 compatible

 

packets will be transmitted.

 

v2_only - Specifies that only RIP v2 packets will be

 

transmitted.

 

rx_mode Determines how received RIP packets will be

 

interpreted – as RIP version V1 only, V2 Only, or V1 or V2.

 

This entry specifies which version of the RIP protocol will be

 

used to receive RIP packets. The Disabled entry prevents the

287

Page 290
Image 290
D-Link TM DES-6500 manual RIP Commands, Config rip