D-Link TM DES-6500 manual Vlan Commands, Create vlan

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual

15

VLAN COMMANDS

The xStack DES-6500 incorporates protocol-based VLANs. This standard, defined by the IEEE 802.1v standard maps packets to protocol-defined VLANs by examining the type octet within the packet header to discover the type of protocol associated with it. After assessing the protocol, the Switch will forward the packets to all ports within the protocol-assigned VLAN. This feature will benefit the administrator by better balancing load sharing and enhancing traffic classification. The Switch supports fifteen (15) pre-defined protocols for configuring protocol-based VLANs. The user may also choose a protocol that is not one of the fifteen defined protocols by properly configuring the userDefined protocol VLAN. The supported protocols for the protocol VLAN function on this Switch include IP, IPX, DEC LAT, SNAP, NetBIOS, AppleTalk, XNS, SNA, IPv6, RARP and VINES.

The VLAN commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.

Command	Parameters
create vlan	<vlan_name 32> {tag <vlanid 2-4094> {type {1q_vlan
	{advertisement} [protocol-ip protocol-ipx802dot3 protocol-
	ipx802dot2 protocol-ipxSnap protocol-ipxEthernet2 protocol-
	appleTalk protocol-decLat protocol-sna802dot2 protocol-
	snaEthernet2 protocol-netBios protocol-xns protocol-vines
	protocol-ipV6 protocol-userDefined <hex0x0-0xffff> encap
	[ethernet llc snap all] protocol-rarp]}}
delete vlan	<vlan_name 32>
config vlan	<vlan_name 32> {[add [tagged untagged forbidden] <portlist>
	advertisement [enabled disabled]}
config vlan	<vlan_name 32> delete <portlist>
config gvrp	[<portlist> all] {state [enabled disabled] ingress_checking
	[enabled disabled] acceptable_frame [tagged_only admit_all]
	pvid <vlanid 1-4094>}
enable gvrp
disable gvrp
show vlan	{<vlan_name 32>}
show gvrp	{<portlist>}

Each command is listed, in detail, in the following sections.

create vlan

Purpose	Used to create a VLAN on the Switch.
Syntax	create vlan <vlan_name 32> {tag <vlanid 2-4094> {type {1q_vlan
	{advertisement} [protocol-ip protocol-ipx802dot3 protocol-
	ipx802dot2 protocol-ipxSnap protocol-ipxEthernet2 protocol-
	appleTalk protocol-decLat protocol-sna802dot2 protocol-
	snaEthernet2 protocol-netBios protocol-xns protocol-vines
	protocol-ipV6 protocol-userDefined <hex0x0-0xffff> encap
	[ethernet llc snap all] protocol-rarp]}}
Description	This command allows the creation of a VLAN on the Switch. The user
	may choose between an 802.1Q VLAN or a protocol-based VLAN.
Parameters	<vlan_name 32> − The name of the VLAN to be created.

118