
xStack
config ipif
| vlan <vlan_name 32> − The name of the VLAN corresponding to |
| the previously created IP interface. If a primary and secondary IP |
| interface are configured for the same VLAN (subnet), the user |
| cannot change the VLAN of the IP interface. |
| state [enabled disabled] − Allows you to enable or disable the IP |
| interface. |
| bootp − Allows the selection of the BOOTP protocol for the |
| assignment of an IP address to the Switch’s System IP interface. |
| dhcp − Allows the selection of the DHCP protocol for the |
| assignment of an IP address to the Switch’s System IP interface. |
Restrictions | Only |
|
|
Example usage:
To configure the IP interface System:
Command: config ipif System ipaddress 10.48.74.122/8
Success.
enable ipif
Purpose | Used to enable an IP interface on the Switch. |
Syntax | enable ipif {<ipif_name 12> all} |
Description | This command will enable the IP interface function on the Switch. |
Parameters | <ipif_name 12> − The name of a previously configured IP interface |
| to enable. Enter an alphanumeric entry of up to twelve characters |
| to define the IP interface. |
| all – Entering this parameter will enable all the IP interfaces |
| currently configured on the Switch. |
Restrictions | None. |
|
|
Example usage:
To enable the ipif function on the Switch:
DES-6500:4#enable ipif s2
Command: enable ipif s2
Success.
136