xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual

config cpu access_profile

vlan <vlan_name 32> Specifies that the access profile will apply to only to this VLAN.

source_mac <macaddr> Specifies that the access profile will apply to this source MAC address.

destination_mac <macaddr> Specifies that the access profile will apply to this destination MAC address.

ethernet_type <hex 0x0-0xffff>Specifies that the access profile will apply only to packets with this hexadecimal 802.1Q Ethernet type value in the packet header.

ip Specifies that the Switch will look into the IP fields in each packet.

vlan <vlan_name 32> Specifies that the access profile will apply to only this VLAN.

source_ip <ipaddr> Specifies that the access profile will apply to only packets with this source IP address.

destination_ip <ipaddr> Specifies that the access profile will apply to only packets with this destination IP address.

dscp <value 0-63>Specifies that the access profile will apply only to packets that have this value in their Type-of-Service (DiffServ code point, DSCP) field in their IP packet header

icmp Specifies that the Switch will examine the Internet Control Message Protocol (ICMP) field within each packet.

type <value 0-255>Specifies that the access profile will apply to this ICMP type value.

code <value 0-255>Specifies that the access profile will apply to this ICMP code.

igmp Specifies that the Switch will examine the Internet Group Management Protocol (IGMP) field within each packet.

type <value 0-255>Specifies that the access profile will apply to packets that have this IGMP type value.

tcp Specifies that the Switch will examine the Transmission Control Protocol (TCP) field within each packet.

src_port <value 0-65535>Specifies that the access profile will apply only to packets that have this TCP source port in their TCP header.

dst_port <value 0-65535>Specifies that the access profile will apply only to packets that have this TCP destination port in their TCP header.

protocol_id <value 0-255>Specifies that the switch will examine the Protocol field in each packet and if this field contains the value entered here, apply the following rules.

udp Specifies that the Switch will examine the Transmission Control Protocol (TCP) field within each packet.

src_port <value 0-65535>Specifies that the access profile will apply only to packets that have this UDP source port in their header.

dst_port <value 0-65535>Specifies that the access profile will apply only to packets that have this UDP destination port

231

Page 234
Image 234
D-Link TM DES-6500 manual 231