D-Link TM DES-6500 Create vrrp vrid, Vrid vrid 1-255 ipif ipifname 12 ipaddress ipaddr state

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual

create vrrp vrid

Purpose	To create a VRRP router on the Switch.
Syntax	vrid <vrid 1-255> ipif <ipif_name 12> ipaddress <ipaddr> {state
	[enable disable] priority <int 1-254> advertisement_interval
	<int 1-255> preempt [true false] critical_ip <ipaddr>
	critical_ip_state [enable disable]}
Description	This command is used to create a VRRP interface on the Switch.
Parameters	vrid <vrid 1-255>- Enter a value between 1 and 255 to uniquely
	identify this VRRP group on the Switch. All routers participating in
	this group must be assigned the same vrid value. This value MUST
	be different from other VRRP groups set on the Switch.
	ipif <ipif_name 12> - Enter the name of a previously configured IP
	interface that you wish to create a VRRP entry for. This IP interface
	must be assigned to a VLAN on the Switch.
	ipaddress <ipaddr> - Enter the IP address that will be assigned to
	the VRRP router. This IP address is also the default gateway that
	will be statically assigned to end hosts and must be set for all routers
	that participate in this group.
	state [enable disable] - Used to enable and disable the VRRP
	router on the Switch.
	priority <int 1-254>- Enter a value between 1 and 254 to indicate the
	router priority. The VRRP Priority value may determine if a higher
	priority VRRP router overrides a lower priority VRRP router. A higher
	priority will increase the probability that this router will become the
	Master router of the group. A lower priority will increase the
	probability that this router will become the backup router. VRRP
	routers that are assigned the same priority value will elect the
	highest physical IP address as the Master router. The default value
	is 100. (The value of 255 is reserved for the router that owns the IP
	address associated with the virtual router and is therefore set
	automatically.)
	advertisement_interval <int 1-255> - Enter a time interval value, in
	seconds, for sending VRRP message packets. This value must be
	consistent with all routers participating within the same VRRP group.
	The default is 1 second.
	preempt [true false] - This entry will determine the behavior of
	backup routers within the VRRP group by controlling whether a
	higher priority backup router will preempt a lower priority Master
	router. A true entry, along with having the backup router’s priority set
	higher than the masters priority, will set the backup router as the
	Master router. A false entry will disable the backup router from
	becoming the Master router. This setting must be consistent with all
	routers participating within the same VRRP group. The default
	setting is true.
	critical_ip <ipaddr> - Enter the IP address of the physical device that
	will provide the most direct route to the Internet or other critical
	network connections from this virtual router. This must be a real IP
	address of a real device on the network. If the connection from the
	virtual router to this IP address fails, the virtual router will be disabled
	automatically. A new master will be elected from the backup routers
	participating in the VRRP group. Different critical IP addresses may
	be assigned to different routers participating in the VRRP group, and
	can therefore define multiple routes to the Internet or other critical

263