xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual

config igmp_snooping querier

 

interval) + (1 x query response interval).

 

Other querier present interval—Amount of time that must

 

pass before a multicast router decides that there is no

 

longer another multicast router that is the querier. This

 

interval is calculated as follows: (robustness variable x

 

query interval) + (0.5 x query response interval).

 

Last member query count—Number of group-specific

 

queries sent before the router assumes there are no

 

local members of a group. The default number is the

 

value of the robustness variable.

 

By default, the robustness variable is set to 2. You might

 

want to increase this value if you expect a subnet to be

 

lossy.

 

last_member_query_interval <sec 1-25> The maximum amount

 

of time between group-specific query messages, including those

 

sent in response to leave-group messages. Lower this interval to

 

reduce the amount of time it takes a router to detect the loss of

 

the last member of a group.

 

state [enabled disabled] Allows the Switch to be specified as

 

an IGMP Querier or Non-querier.

Restrictions

Only administrator-level users can issue this command.

 

 

Example usage:

To configure the igmp snooping:

DES-6500:4#config igmp_snooping querier default query_interval 125 state enabled Command: config igmp_snooping querier default query_interval 125 state enabled

Success.

DES-6500:4#

enable igmp_snooping

Purpose

Used to enable IGMP snooping on the Switch.

Syntax

enable igmp_snooping {forward_mcrouter_only}

Description

This command allows you to enable IGMP snooping on the

 

Switch. If forward_mcrouter_only is specified, the Switch will

 

only forward all multicast traffic to the multicast router, only.

 

Otherwise, the Switch forwards all multicast traffic to any IP

 

router.

Parameters

forward_mcrouter_only Specifies that the Switch should only

 

forward all multicast traffic to a multicast-enabled router.

 

Otherwise, the Switch will forward all multicast traffic to any IP

 

router.

Restrictions

Only administrator-level users can issue this command.

 

 

Example usage:

145

Page 148
Image 148
D-Link TM DES-6500 manual Enable igmpsnooping, Lastmemberqueryinterval sec 1-25 − The maximum amount