Chapter 2 Avaya C460 CLI Commands
The syntax for this command is:
set port trap <module>/<port> {enabledisable}
module | Number of the module |
port | Number of the port on the module. |
| You can also specify a range of ports separated by a dash, for |
| example, |
enable | Enable uplink/downlink traps |
disable | Disable uplink/downlink traps |
Example: |
|
C460-1# set port trap 3/2 enable
Port 3/2 up/down trap enabled.
set port vlan
User level: read-write, admin.
Use the set port vlan command to set the port VLAN ID (PVID). If adding a new VLAN, the VLAN number must be within the range.
You need to define a vlan before setting a port VLAN ID.
The syntax for this command is:
set port vlan <vlan_num> <module>/<port>
vlan_num | Number identifying the VLAN. |
module | The module number |
port | Number of the port on the module. |
| You can also specify a range of ports separated by a dash, for |
| example, |
120 | Avaya C460 Reference Guide |