Avaya C460 manual Ip rip split-horizon

Chapter 2 Avaya C460 CLI Commands

necessary.

Use the ip rip send-receivecommand to set the RIP Send and Receive mode on an interface. The default state is talk-listen.

The syntax for this command is:

ip rip send-receive-mode<mode>[<default route metric>]

mode	talk-listen - Set RIP to receive and transmit
	updates on the interface.
	talkdefault-listen - Set RIP to receive
	updates on the interface and send only a default
	route.
default route metric	Integer value

Example:

To set the RIP Send and Receive mode on the interface “marketing” to be listen-only:

Router-1(configure-if:marketing) # ip rip send-receive-mode talk listen

Done!

ip rip split-horizon

User level: read-write, admin.

You can only access this command in interface mode.

Type interface [name] at the command prompt to enter interface mode if necessary.

Use the ip rip split-horizoncommand to enable split-horizon mechanism. Use the no ip rip split-horizoncommand to disable the split-horizon.

By default split-horizon is enabled.

The split-horizon technique prevents information about routes from exiting the router interface through which the information was received. This prevents routing loops.

The syntax for this command is:

[no] ip rip split-horizon

58 Avaya C460 Reference Guide