Chapter 2 Avaya C460 CLI Commands

set interface ppp {enableenable-alwaysdisableoffreset}

enable

Enable PPP and enter modem mode.

enable-always

Enter modem mode every time that the proprietary modem

 

cable is plugged into the console port.

disable

Disable PPP and enter terminal mode

off

Disconnect the active PPP session.

reset

Reset the connected modem.

Example:

 

C460-1#set interface ppp reset

PPP has reset the connected modem.

Example:

C460-1#set interface ppp enable

Entering the Modem mode within 60 seconds...

Please check that the proprietary modem cable is plugged into the console port

Example:

C460-1#set interface ppp disable

Entering the Terminal mode immediately

set ip route

User level: read-write, admin.

Use the set ip route command to adds a route to the IP routing table. You can configure from 1 to 10 default static gateways for a C460 switch.

The syntax for this command is:

set ip route <destination> <netmask> <gateway>

destination

IP address of the network, or specific host to be added

netmask

Subnet mask

gateway

IP address of the router

92

Avaya C460 Reference Guide

Page 104
Image 104
Avaya C460-1#set interface ppp reset, C460-1#set interface ppp enable, C460-1#set interface ppp disable, Set ip route