Chapter 2 Avaya C460 CLI Commands

sync spv

User level: read-write, admin.

Use the sync spv command to synchronize the following between an Active Supervisor Module and Halted Supervisor Module:

Boot bank

Firmware images

Device manager image

You can only execute this command from the active Supervisor Module CLI.

The syntax for this command is:

sync spv

The synchronization may take up to 90 seconds to complete.

Example:

C460-1(super)# sync spv

This command may overwrite the neighbor SPV software and reset it

***Confirmation *** - do you want to continue (Y/N)? y Copying Bank A to the neighbor SPV ...

Copying Bank A to the neighbor SPV done Copying Bank B to the neighbor SPV ...

Copying Bank B to the neighbor SPV done

Copying Embedded Web image to the neighbor SPV ...

Copying Embedded Web image to the neighbor SPV done Setting boot bank of the neighbor SPV ...

Setting boot bank of the neighbor SPV done Setting chassis sync on for the neighbor SPV...

Setting chassis sync on for the neighbor SPV done SPVs are resetting.

Please wait till the process is finished. The SPVs will be synchronized after the reset is completed

The configuration is synchronized after you perform a reset.

tech

Use the tech command to enter tech mode. This command is reserved for service personnel use only.

224

Avaya C460 Reference Guide

Page 236
Image 236
Avaya manual Sync spv, C460-1super# sync spv, Tech