Avaya C460 manual Ip netmask-format, No ip netmask-format mask-format

Chapter 2 Avaya C460 CLI Commands

The possible values of mode are:

both	Netbios packets received on the interface
	rebroadcasted to other interfaces and netbios packets
	received on other interfaces are rebroadcasted into
	this interface.
disable	Netbios packets are not rebroadcasted into or out of
	this interface.

Example:

To enable rebroadcasting of netbios packets received by and sent from the interface “marketing”:

Router-1(config-if:marketing)# ip netbios-rebroadcast both

ip netmask-format

User level: read-write, admin.

If you are at the “read-write” user level, you can only access this command in Configure mode.

Type configure at the command prompt to enter configure mode.

Use the ip netmask-formatcommand to specify the format of netmasks in the show command output.

Use the no ip netmask-formatcommand to restores the default format which is a dotted decimal.

The syntax for this command is:

[no] ip netmask-format <mask-format>

The possible mask formats are:

bitcount	Addresses are followed by a slash and the total number of bits
	in the netmask. For example 17
decimal	The network masks are in dotted decimal notation. For
	example, 255.255.255.0.
hexadecimal	The network masks are in hexadecimal format as indicated by
	the leading 0X. For example, 0XFFFFFF00.

50 Avaya C460 Reference Guide