Avaya manual Set trunk, C460-1#set trunk 3/3 dot1q, Set vlan, C460-1#set vlan 3 name gregory

Chapter 2 Avaya C460 CLI Commands

set trunk

User level: read-write, admin.

Use the set trunk command to configure the VLAN tagging mode of a port.

set trunk <module/port> [value]

module	Number of the module (3-6).
port	Number of the port on the module. If you do not specify a
	number, the vlan tagging mode is set for all the ports on the
	module.
	You can also specify a range of ports separated by a dash,
	for example, 4/5-13 for ports 5 to 13 on module 4.
value	• off – forces the port to become a non-tagging port and
	persuade the neighboring port to become a non-tagging
	port. The port becomes a non-tagging port even if the
	neighbor port does not agree to become a non-tagging
	port.
	• dot1q – specifies an IEEE 802.1Q tagging on a Fast
	Ethernet or Gigabit Ethernet port.
Example:

C460-1#set trunk 3/3 dot1q

Dot1Q VLAN tagging set on port 3/3.

set vlan

User level: read-write, admin.

Use the set vlan command to configure VLANs.

The syntax for this command is:

set vlan <vlan-id> [name <vlan-name>]

vlan-id	vlan number
vlan-name	vlan name
Example:

C460-1#set vlan 3 name gregory

VLAN id 3, vlan-name gregory created.

138 Avaya C460 Reference Guide