Chapter 2 Avaya C460 CLI Commands

default-metric (RIP)

User level: read-write, admin.

You can only access this command in the RIP context

Type router rip at the command prompt to enter interface mode if necessary.

Use the default metric command to set the interface RIP route metric.

Use the no default metric command to restore the default value.

The default metric is 1.

The syntax for this command is:

[no] default-metric <number>

number

The interface RIP route metric value. The range is 1 to 15.

Example:

Router-1 (configure router:rip) # default metric 10

Done!

disable interface

User level: read-write, admin.

Use the disable interface command to disables the inband or outband interface.

The syntax for this command is:

disable interface [outband inband]

outband

Disables the outband interface

inband

Disables the inband interface

Example:

 

C460-1#disable interface outband

You must reset the device in order for the change to take effect.

Avaya C460 Reference Guide

31

Page 43
Image 43
Avaya manual Default-metric RIP, Disable interface outband inband, C460-1#disable interface outband