Avaya manual C460-1#set port redundancy-intervals 100, Set port spantree

Chapter 2 Avaya C460 CLI Commands

The syntax for this command is:

set port redundancy-intervals <min-time-between-switchovers><switchback-interval> none

min-time-between-switchovers	The minimum time between redundancy
	switchovers for each pair (in milliseconds).
switchback-interval	The period the primary port link has to be
	“up” before the system switches back (in
	milliseconds).
	• If switchback interval is zero, the system
	never switches back
	• If it is one, switchback occurs immediately
	after the primary port link returns
none	The system switches bank only if the
	secondary link fails.
Example:

C460-1#set port redundancy-intervals 100 20

Done!

set port spantree

User level: read-write, admin.

Use the set port spantree command to enable or disable the spanning tree mode for specific switch ports.

The syntax for this command is:

set port spantree {enabledisable} [module/port]

enabledisable	Enables or disables the spanning tree mode for the
	specified ports.
Module	Module number
Port	Port number
Example:

C460-1#set port spantree enable 3/1

port 3/1 was enabled on spantree

116 Avaya C460 Reference Guide