Avaya C460 manual Set port auto-negotiation-flowcontrol-advertisement, Set port channel

Chapter 2 Avaya C460 CLI Commands

set port auto-negotiation-flowcontrol-advertisement

User level: read-write, admin.

Use the set port auto-negotiation-flowcontrol-advertisementcommand to set the flowcontrol advertisement for a Gigabit port when performing autonegotiation.

The syntax for this command is:

set port auto-negotiation-flowcontrol-advertisement <module>/

<port> [mode]

module	Number of the module (3-6).
port	Number of the port on the module. If you do not specify a
	number, all the ports on the module are set.
	You can also specify a range of ports separated by a dash,
	for example, 4/5-13 for ports 5 to 13 on module 4.
mode	• no-flowcontrol – the port will advertise no pause
	capabilities.
	• asym-tx-only – the port will advertise asymmetric Tx
	pause capabilities only.
	• sym-only – the port will advertise symmetric pause
	capabilities only.
	• sym-and-asym-rx – the port will advertise both
	symmetric and asymmetric Rx pause capabilities.
Example:

C460-1#set port auto-negotiation-flowcontrol-advertisement 2/5 asym-tx-only

Port 2/5 pause capabilities was set

set port channel

User level: read-write, admin.

Enables or disables a Link Aggregation Group (LAG) interface on the switch. LAG creation requires a LAG name to be specified. There is no default name.

You can also add or remove a port from an existing LAG. All ports in the LAG are configured with the parameters of the first port that is added to the LAG. These parameters include port administrative status, speed, duplex, autonegotiation mode, VLAN ID, tagging mode, binding mode, and priority level. When adding a port to an existing LAG, the user must type the same LAG-name (or no LAG-name),

Avaya C460 Reference Guide 99