Avaya manual Show port edge state, C460-1show port edge state, Show port flowcontrol

Chapter 2 Avaya C460 CLI Commands

show port edge state

User level: read-only, read-write, admin.

Use the show port edge state command to show a port’s edge admin and operational RSTP state.

A port can be set to admin state of edge port, but if a BPDU is received on this port the oper state is changed to non-edge state.

The syntax for this command is:

show port edge state <module/port>

module	Number of the module (3-6). If you do not specify a number, the
	ports on all the modules are shown.
port	Number of the port on the module. If you do not specify a number,
(Optional)	all the ports on the module are shown.
	You can also specify a range of ports separated by a dash, for
	example, 4/5-13 for ports 5 to 13 on module 4.
Example:

C460-1>show port edge state

Port	admin state	oper state
-------	-------------	-------------
1/1	edge-port	edge-port
1/2	non-edge-port	non-edge-port

show port flowcontrol

User level: read-only, read-write, admin.

Use the show port flowcontrol command to display per-port status information related to flow control.

The syntax for this command is:

show port flowcontrol [<module>[/<port>]]

module	Number of the module (3-6). If you do not specify a number, all
(Optional)	modules are shown.
port	Number of the port on the module. If you do not specify a
(Optional)	number, all ports on the specified module are shown.

194 Avaya C460 Reference Guide