Avaya manual Nvram initialize switch all, C460-1#nvram initialize, Passive-interface

Chapter 2 Avaya C460 CLI Commands

nvram initialize {switch all}

switch	Resets all the switch information (Layer 2 only).
all	Resets all parameters including routing parameters in the
	switch.
Example:

C460-1#nvram initialize

This command will restore factory defaults, and can disconnect your telnet session

***Reset *** - do you want to continue (Y/N)? y Connection closed by foreign host

The nvram initialize command does not alter the Active/Standby status of the Supervisor modules.

passive-interface

User level: read-write, admin.

You can only access this command in Router-OSPF mode.

Type router ospf at the command prompt to enter Router -OSPF mode if necessary.

Use the passive interface command to allow interfaces to be flooded into the OSPF domain as OSPF routes and not external routes.

Use the no passive interface command to disble the flooding.

An interface becomes passive only if you use the network command to enable OSPF to run on the interface.

The syntax for this command is:

passive-interface <interface-name/net addr>

interface-name / Name of interface or IP address. net addr

Example:

Router-1#passive-interface FastEthernet 1.10

70 Avaya C460 Reference Guide