Avaya manual Set port name, C460-1#set port name 4/21 arthur, Set port negotiation

Chapter 2 Avaya C460 CLI Commands

Example:

C460-1#set port mirror source-port 3/9 mirror-port 4/10

direction both

Mirroring both Rx and Tx packets from port 3/9 to port 4/10 is enabled

set port name

User level: read-write, admin.

Use the set port name command to configure a name for a port. If you do not specify a name, the port name remains blank.

The syntax for this command is:

set port name <module>/<port> [value]

module	Number of the module (3-6).
port	Number of the port on the module. If you do not specify a
	number, the same name is set for all the ports on the module.
	You can also specify a range of ports separated by a dash, for
	example, 4/5-13 for ports 5 to 13 on module 4.
value	Name (up to 16 characters)
Example:

C460-1#set port name 4/21 arthur

Port 4/21 name set.

If you wish to define a name which includes spaces, you must enclose the entire name in quotation marks, for example “new york”.

set port negotiation

User level: read-write, admin.

Use the set port negotiation command to enable or disable the link negotiation protocol on the specified port. This command applies to Fast Ethernet or Gigabit Ethernet ports.

When negotiation is enabled, the speed and duplex of the Fast Ethernet ports are determined by auto-negotiation.

If negotiation is disabled, the user can set the speed and duplex of the Fast Ethernet

Avaya C460 Reference Guide 111