Avaya C460 manual Show port auto-negotiation-flowcontrol-advertisement, Show port channel

Chapter 2 Avaya C460 CLI Commands

show port auto-negotiation-flowcontrol-advertisement

User level: read-write, admin.

Use the show port auto-negotiation-flowcontrol-advertisementcommand to display the flowcontrol advertisement for a Gigabit port used to perform auto-negotiation.

The syntax for this command is:

set auto-negotiation-flowcontrol-advertisement [module/port]

[mode]
module	Number of the module (3-6). If you do not specify a number,
(Optional)	the ports on all the modules are shown.
port	Number of the port on the module. If you do not specify a
(Optional)	number, all the ports on the module are shown.
	You can also specify a range of ports separated by a dash, for
	example, 4/5-13 for ports 5 to 13 on module 4.
mode	no-flowcontrol, asym-tx-only, sym-only or sym-and-asym-rx
Example:

C460-1>show port auto-negotiation-flowcontrol- advertisement 4/49

Port 4/49 pause capabilities was set

show port channel

User level: read-only, read-write, admin.

Use the show port channel command to display Link Aggregation Group (LAG) information for a specific switch or port.

The syntax for this command is:

show port channel [<module>[/<port>]] [info]

module	Number of the module (3-6). If you do not specify a number,
(Optional)	the modules on all the switch are shown.
port	Number of the port on the module. If you do not specify a
(Optional)	number, all the ports on the module are shown.
	You can also specify a range of ports separated by a dash, for
	example, 4/5-13 for ports 5 to 13 on module 4.

188 Avaya C460 Reference Guide