Avaya manual C460-1#set snmp retries, Set snmp timeout number, C460-1#set snmp timeout

Chapter 2 Avaya C460 CLI Commands

Example:

C460-1#set snmp retries 10

SNMP retries is set to 10

set snmp timeout

User level: read-write, admin.

Use the set snmp timeout command to set the SNMP timeout in seconds. This command is useful for access using the C460 Manager.

The syntax for this command is:

set snmp timeout <number>

number Timeout in seconds

Example:

C460-1#set snmp timeout 2000

the SNMP Timeout is set to 2000

set snmp trap

User level: read-write, admin.

Use the set snmp trap command to add an entry into the SNMP trap receiver table and to enable or disable the different SNMP traps for a specific receiver.

First add the rcvr_addr and then enable/disable the different traps for it.

The syntax for this command is:

set snmp trap <rcvr_addr>

set snmp trap <rcvr_addr> {enabledisable} {allconfigfault...}

enable	Activate SNMP traps
disable	Deactivate SNMP traps
all	(Optional) Specify all trap types
config	(Optional) Specify the ConfigChange trap from the TRAP-MIB.
fault	(Optional) Specify the Fault trap from the TRAP-MIB.
rcvr_addr	IP address or IP alias of the system to receive SNMP traps

Avaya C460 Reference Guide 129