Avaya C460 manual Set spantree default-path-cost, Set spantree enable/disable

Chapter 2 Avaya C460 CLI Commands

set spantree default-path-cost

User level: privileged, supervisor.

Use the set spantree default-path-costcommand to set the version of the spanning tree default path costs that are to be used by this bridge.

The syntax for this command is:

set spantree default-path-cost <path-cost>

path-cost	•	common-spanning-tree - compatible with IEEE802.1D
		standard
	•	rapid-spanning-tree - compatible with IEEE802.1W
		standard
Example:

C460-1#set spantree default-path-cost rapid-spanning-tree

Spanning tree default path costs is set to rapid spanning tree.

set spantree enable/disable

User level: read-write, admin.

Use the set spantree command to enable or disable the spanning-tree algorithm for the switch.

When you disable STP, blocking ports are disabled in order to prevent loops in the network. As a result, you need to wait 30 seconds before disabling STP if you reset the switch, enable STP, or insert a new station.

The syntax for this command is:

set spantree {enabledisable}

Example:

C460-1#set spantree enable bridge spanning tree enabled.

C460-1#set spantree disable bridge spanning tree disabled.

Avaya C460 Reference Guide 131