Chapter 2 Avaya C460 CLI Commands

show port redundancy

User level: read-only, read-write, admin.

Use the show port redundancy command to display information about software port redundancy schemes defined for the switch.

The syntax for this command is:

show port redundancy

Example:

C460-1>show port redundancy

Redundancy Name

Primary Port

Secondary Port

Status

-----------------

--------------

----------------

--------

gregory

3/48

3/47

secondary

amir

3/46

3/45

secondary

lior

3/1

3/2

primary

arie

3/34

3/33

secondary

Minimum Time between Switchovers: 1

Switchback interval: 3

show port trap

User level: read-only, read-write, admin.

Use the show port trap command to display information on SNMP generic link up/down traps sent for a specific port.

The syntax for this command is:

show port trap [<module>[/<port>]]

module

Number of the module (3-6). If you do not specify a number,

(Optional)

the ports on all the modules are shown.

port

Number of the port on the module. If you do not specify a

(Optional)

number, all the ports on the module are shown.

 

You can also specify a range of ports separated by a dash, for

 

example, 4/5-13 for ports 5 to 13 on module 4.

Example:

 

C460-1>show port trap 4/1

Port 4/1 up/down trap is disabled

Avaya C460 Reference Guide

197

Page 209
Image 209
Avaya manual Show port redundancy, C460-1show port redundancy, Show port trap, C460-1show port trap 4/1