Avaya C460 manual Timers ospf, No timers spf spf-holdtime

Chapter 2 Avaya C460 CLI Commands

invalid	RIP invalid route timer in seconds (minimum =30;
	default = 180)

The Invalid Route Timer value must be larger than the Update Timer value. It is recommended that it be at least three times greater.

In any configuration all adjacent routers must have the same values for each of the timer parameters. It is possible to have different values for the timers on two adjacent routers, provided the Invalid Timer value is at least three times greater on one of the routers than the Update Timer value on the other router.

Example:

Router-1 (configure router:rip) # timers basic 30 180

timers ospf

User level: read-write, admin.

You can only access this command in Router-OSPF mode.

Type router ospf at the command prompt to enter Router-OSPF mode if necessary.

Use the timers spf command to set the delay between runs of OSPF SPF calculation.

Use the no timers spf command to restore the default (3 seconds).

The syntax for this command is:

[no] timers spf <spf-holdtime>

spf-holdtime	The time in seconds of the delay between runs of
	OSPF’s SPF calculation.

Example:

Router-1 (configure router:ospf) # timers spf 5

Done!

Avaya C460 Reference Guide 227